FCX4000-UM-251-9370 12-4
12 Target electrical component for WEEE instruction
♦ How to remove the electrical component of the WEEE instruction
• Removing (A) Main Board
(1) Remove the two M4L8 binding head screws holding the left top cover, and then detach it.
Left top cover
M4L8 binding head screw
(2) Remove the two studs from the RS-232C I/F connector screws.
RS-232C I/F connector screw
(3) Disconnect all cables from the main board.
Main Board
M3L6 binding head screw
Stud
(4) Remove the four M3L6 binding head screws holding the main board, and then detach the main board
from the main box.
To Next Page
Loading...
