FCX4000-UM-251-9370 7-21
7 DISASSEMBLY AND ASSEMBLY
(8) Loosen the two M4L6 binding head screws xing from the bottom of front X belt tension bracket.
Front X belt tension bracket
Access the screws from these holes.
M4L6 binding head screws xing front X belt tension.
(9) Loosen the two belt tension adjustment screws to loosen the front X belt tension.
Use these access holes to loosen the X belt tension.
(10) Move the Y bar to the access holes of screws.
Remove the four M3L10 binding head screws holding the belt stoppers, and then detach the front X belt
from the front X slider and the pulleys.
M3L10 binding head screw
Belt stopper
Front X belt
Access the screws from these holes.
To Next Page
Loading...