GreenWorks CU800 - Chapter 7 Electrical System Malfunction Inspection; Electrical Components

ELECTRICAL SYSTEM MALFUNCTION INSPECTION CU800 Service Manual
202
8. Check the sensor of
acceleration.
Change the damaged
throttle sensor.
9. Check the “forward / reverse”
switch for water penetration.
Remove water from switch.
10.Check the switch of
“Forward/Reverse”.
Change the damaged
switch.
15
Mode cannot switch
out of L mode,
maximum speed ＜
24km/h.
1. Check the Seatbelt buckle switch.
Change the Seatbelt buckle
switch.
2. Check the Seatbelt buckle switch
cables.
Repair cable.
3. Low soc.
Charge the battery.
4. Check the instrument display
fault code
Repair the vehicle according
to the fault code description.
7.1 ELECTRICAL COMPONENTS