GENERAL INFORMATION CU800 Service Manual
30
1. Prying is generally the easiest and most
effective method of removing a seal from the
housing. Always place a rag underneath the
pry tool to prevent damage to the housing.
Note the seal’s installed depth or if it is installed
flush.
2. Pack waterproof grease in the seal lips before
the seal is installed.
3. Install seals with the manufacturer’s numbers
or marks facing out.
4. Install seals with a socket or driver placed on
the outside of the seal as shown in. Drive the
seal squarely into the housing until it is to the
correct depth or flush as noted during removal.
Never install a seal by hitting against the top
of it with a hammer.
1.12 BASIC DRIVING AND OPERATING METHODS
Please read and truly comprehend the content of this manual, pay attention to those contents
marked with CAUTION and WARNING. Make sure all drivers already comprehended contents of this
manual and all operating skills before driving.
WARNING:
⚫ Make sure the road or place is suitable for driving.
⚫ Make sure obey related warning sign.
⚫ Make sure drivers already comprehended contents of this manual and all operating skills.
⚫ To guide the driver for his first driving.
1.12.1 Proper Driving Methods
1. Use the steering wheel to make the wheel to
the right direction and make sure there are no
obstructions on the road.
2. Make sure the F/N/R switch is in N position.
To Next Page
Loading...