GENERAL INFORMATION CU800 Service Manual
42
⚫ Do not pull on the DC cord Do not twist, rock or bend the plug. To disconnect the
charger plug from AC power receptacle, grasp the plug by the handle and pull the plug
straight out of the receptacle.
⚫ Do not connect a charger to the receptacle if the charger cord, plug, or the vehicle
receptacle is broken, damaged in any manner, or does not make a good electrical
connection. Fire or personal injury can result, have it replaced by a qualified service
person immediately.
⚫ Failure to follow these instructions could result in damage to the charger cord, the plug,
and (or) the vehicle receptacle.
⚫ Do not use a charger if:
– The plug is too loose or does not make a good connection
– The plug and receptacle feel hotter than normal during charge.
– The plug pins or receptacle contacts are bent or corroded.
– The plug, receptacle, or cords are cut, worn, have any exposed wires or are damaged in
any way.
⚫ Using the charger with any of the above symptoms could result in a fire, property
damage, personal injury, or death.
1.16.5 Charging Quantity Indicator
NOTE
Before charge the vehicle, make sure to close all of the switches, including the power
switch of the accessories which are installed in the vehicle.
To Next Page
Loading...
