GreenWorks CU800 - Changing the Tail;Brake Light Bulb

MAINTENANCE AND ADJUSTMENT OF EV CU800 Service Manual
87
NOTE
Avoid touching the glass part of the bulb.
Keep it free from oil; otherwise, the transparency of the glass, life of the bulb, and luminous
flux will be adversely affected. If oil gets on the bulb, thoroughly clean it with a cloth
moistened with alcohol or lacquer thinner.
• Close the hood.
3.3.5 Changing the Tail/Brake Light Bulb
1. Remove:
• Rear panel
• tail/brake light bulb holder ①
• bulb
NOTE
Turn the bulb holder counterclockwise and
remove the defective bulb.
WARNING
Keep flammable products and your hands
away from the bulb while it is on, since it
will be hot. Do not touch the bulb until it
cools down.
Secure the new bulb with the tail/brake light bulb holder.
NOTE
Avoid touching the glass part of the bulb.
Keep it free from oil; otherwise, the
transparency of the glass, life of the bulb,
and luminous flux will be adversely affected.
If oil gets on the bulb, thoroughly clean it
with a cloth moistened with alcohol or
lacquer thinner.
• tail/brake light bulb holder (with bulb) ①
• headlight bulb holder (with bulb)
• headlight bulb holder cover
2. Install:
• bulb new