GENERAL INFORMATION CU800 Service Manual
34
1.13 DAILY SAFE CHECKING
Before driving, it is necessary to make a daily safe checking of the vehicle, so that you can found
any possible problem and failure.
If you find any failure, adjustment or maintenance must be carried out immediately; otherwise you
may cause serious injury or property damage.
1.13.1 Daily Safe Checking Items
General: All the parts should be in place and properly installed. Be sure that all nuts, bolts, and
screws are tight.
Fasteners: Check all nuts, bolts, screws if loosened, re-tighten loose fasteners.
Tires: Check tire pressure is correct or not. Make a visual inspection of tire abrasion, if the tires were
worn out or have more severe cracks or unusual drum package, replace it with the new tire.
WARNING:
Left/right tires must be replaced at the same time. Otherwise, there will be deviation and
other failures which led to loss of control or roll-over accident.
Wheel (rim): Check whether the wheel rust or collision deformation, if there is serious corrosion or
deformation, please change the wheel, otherwise, the tires may fell out from the wheel and cause the
accident.
DTCS: After power on according to the standard, check whether the instrument has Error code.
NOTE
The vehicle can only be driven after the Error is confirmed and eliminated according to the
Error code table, Serious failure may damage the safety of the EV and even the user's life.
To Next Page
Loading...
