GreenWorks CU800 - Changing the Differential Gear Oil

MAINTENANCE AND ADJUSTMENT OF EV CU800 Service Manual
- 71 -
3.2.10 Changing the Differential Gear Oil
1. Place the vehicle on a level surface.
2. Place a receptacle under the differential gear case.
3. Remove:
·Differential gear oil drain bolt ①
4. Drain:
·differential gear oil
5. Install:
·drain plug
10 Nm (1.0 m · kg, 7.2 ft · lb)
NOTE:
Check the gasket (drain plug).
If it is damaged, replace it with new one.
6. Fill:
·differential gear case
Periodic oil change
0.25 L (0.22 Imp qt, 0.26 US qt)
Total amount
0.28L (0.25 lmp qt, 0.3 US qt)
NOTE:
If gear oil is filled to the brim of the oil filler hole,
oil may start leaking from the differential gear
case breather hose. Therefore, check the
quantity of the oil, not its level.
WARNING
Take care not to allow foreign material to enter
the differential gear case.
7. Install:
• oil filler plug
23 Nm (2.3 m · kg, 17 ft · lb)