GSI Audera Pro User Manual
D-0129360 Rev A Page 35 of 231
Connection Status
The connection status icon indicates if the USB connection between the device and the
computer is established.
The checkmark indicates a good connection between the device and the
computer. New data may be collected, and previous patient data may be
reviewed.
The exclamation point indicates a good connection between the device and
the computer, but the device is not the device matching the license on the
computer. The information along the bottom left shows the device serial
number (expected board serial number) and (found board serial number).
The X indicates that there is no USB connection between the device and the
computer. You may still review previously collected data, but no new data
can be collected until a USB connection is established with the device.
PASSWORD
Some administrative items in the program require a password. The default password is
‘gsi’. To change the password, go to the Settings menu, Configuration. You will be
prompted for the password. When the Hardware Setup dialog is displayed, select the
Password menu item in the Hardware Setup and you will be prompted for the new
password.
TESTING
Each test modality has an icon on the toolbar. Select the icon for the test you wish to
perform. When the Test icon is selected, a message dialog is displayed as the program
loads and the system initializes. If the connection to the base unit via the USB cable is
not established, a warning message dialog is displayed with the option to continue (or
not). You may continue without the connection; however, the program will not be able
to collect new data, but you will be able to analyze existing data. A new test modality
window will open. Only one test modality window may be opened at a time. When you
exit from the test modality program, you are returned to the opening screen.
To Next Page
