GSI Audera Pro User Manual
D-0129360 Rev A Page 87 of 231
• Right or Left – Plot Start Time – determines the start of the time window, x-axis
(horizontal) at the bottom of the screen of the right or left column waveform
display. A prompt is presented where you enter the start time (ms). This option
is only enabled in Split Page.
• Right or Left – Plot End Time – determines the end of the time window, x-axis
(horizontal) at the bottom of the screen of the right or left column waveform
display. A prompt is presented where you enter the end time (ms). This option
is only enabled in Split Page.
• Grid – displays vertical lines on the waveform display area. This item is a toggle
to turn on/off the grid.
• Apply above to – transfers the settings from the Display menu to other pages.
This item displays a sub-menu of pages when you can apply the settings from
the current display options to all pages or any specific page.
• Clear data on this page – removes the displayed data from the current page.
No data is deleted from the patient.
• Send all data on this page to – moves the data from the current page to a new
page specified by the page selected in the sub-menu of pages.
• Close – exits the pop-up menu.
Cursors
Two cursors are available to display measurements and differences. To turn
on the cursors click the Cursor icon on the Toolbar or Display menu, Display
Cursors. When active, the cursor handles can be found at the bottom left of
the recording area, just above the time scale. Two lines at the top of the page next to
the cursor display the latency and amplitude information (top line) and difference
between the two cursors including a frequency calculation (in parenthesis) of the time
difference.
To Next Page
