GSI Audera Pro User Manual
D-0129360 Rev A Page 51 of 231
occur from the electrical stimulus. You should make sure that the blanking time
is less than the beginning of the response.
• Digital Filter – Option to turn on/off the digital filter that is used with the
incoming collection data. The Digital Filter settings are used to define the digital
filter and since the filtering is performed on the acquisition data it cannot be
undone.
• Digital Filter Settings – The digital filter settings displays the current digital filter
settings and a sub menu where you may define the high and low pass filter
settings. These filter settings are applied to the collection data when the Digital
Filter option is enabled.
o Select High Pass
o Select Low Pass
Recordings
• Path – Displays the location where the data is stored.
• Load Recordings – Opens the Data Files dialog where you may select the
records from the current patient to load to the display for analysis.
• Load Recording from Protocol Results – Opens the Protocol Data Files dialog
where you may select the specific protocol and load recordings collected with
that protocol.
• Save Active Recording – Saves the currently selected recording.
• Save All Recordings – Saves the all the recordings on all pages.
• Save Active Recording As – Allows the currently selected record to be saved as
a different modality type or to a specific file name. Files names use a specific file
naming format that should be followed if the data is to be available to the
program.
o Specific File Name
o ECochG File
o ABR File
o MLR File
o LLR File
o P300/MMN
o cABR File
• Save as ASCII – Allows the data to be saved in a tab delimited text file. The
active waveform or all the data on the page may be saved based on the sub
menu selection.
o Active
o All on Page
• Auto Comment – Opens the comment dialog where you may enter a comment.
This comment is appended to each new test record that is collected until it is
changed, or the program restarted.
To Next Page
