GSI Audera Pro User Manual
D-0129360 Rev A Page 54 of 231
and the latest at the bottom. If you are on a split screen layout or your data
contains both right and left ears, the left and right ear waveforms will be placed
on separate sides.
• Arrange by Stimulation Rate – Arranges the waveforms on the page by the
stimulus rate used for the data collection. The faster stimulus rate for the
acquired waveform is placed at the top and the slowest rate at the bottom. If
you are on a split screen layout or your data contains both right and left ears, the
left and right ear waveforms will be placed on separate sides.
• Display Recording Label – Opens a sub menu that allows you to display
additional information about the recording. The information is placed below the
waveform under the waveform handle and stimulus level information. The
stimulus information indicates the AC/BC for air/bone conduction and the
stimulus type and ear abbreviation. The Rate information displays the rate in
stimuli per second.
o Stimulus Information
o Rate Information
• Display Text next to Peak Label – When you have marked a point on the
waveform, you have an option to display the latency and amplitude information
next to the peak label. The menu option opens a sub menu that allows you to
choose which data to display or remove the peak text labels.
o Apply to Acquired Data
o Apply to All Data
o Apply to All Data on Page
o Apply to Selected Data
o Remove from All Data
o Remove from All Data on Page
o Remove from Selected Data
• Display Baseline – places a horizontal line (at 0 uV) through each waveform.
The checkmark indicates the status (On/Off). This option is a toggle and is Off by
default.
• Display Cursors – Displays/hides 2 vertical cursors at the beginning of the time
plot. The cursor handle at the bottom of the cursor is used to select and move
the cursor. The checkmark indicates the status (On/Off). This option is a toggle
and is Off by default.
• Display Zero-Time Position – Displays a vertical line to indicate time 0 on the
axis. The checkmark indicates the status (On/Off). This option is a toggle and is
Off by default.
• Display Latency-Intensity Graph – Displays the Latency-Intensity graph dialog.
The marked peaks on the current page are plotted on the graph. The graph and
the table of values is presented in the dialog. Options to copy the graph to the
analysis page, print and save the graph are available in the dialog.
To Next Page
