Switch on the FlexxPump as follows:
Prerequisite: “OFF” – the FlexxPump is switched off
1 Touch magnetic surface with magnetic peg Ü238
2 Remove magnetic peg from magnetic surface as soon as the LCD shows
“On” and the yellow LED lights up
3 Wait until the green LED and the LCD flash 2x
If an error is not detected, “On” will be shown on the LCD and the green
LED will light up every 5 s.
The FlexxPump is switched on and ready for operation.
The FlexxPump performs lubrication according to the settings saved.
Maintenance
OPERATING MANUAL FlexxPump4N Lubrication
System
3422906891_v1.0_EN-US
121
To Next Page