GUDEL FlexxPump4 N - Basics; Quantity; Tab. 6-1 Average Lubricant Requirement Per Lubrication Point (U); Tab. 6-2 Recommended Lubrication Quantity (Pt)

6.4.2 Basics
Average lubricant
requirement at a
lubrication point
(U)
The following lubricant quantities should be dispensed at least per lubrication
point. These are empirical values from Güdel. These values can be met only
approximatively due to the number of outputs of the lubricant pump and the
installed splitters.
Size Average lubricant requirement per lubrication point
(U)
1-4 0.3cm
3
/ 100km
5-7 0.4cm
3
/ 100km
Tab.6-1 Average lubricant requirement per lubrication point (U)
Recommended lu-
brication quantity
(P
t
)
The recommended lubrication quantity P
t
can be found in the following table.
System Size 1-4 Size 5-7
3 lubrication points (e.g. EP,
TMF, TMO)
0.9cm
3
/ 100km 1.2cm
3
/ 100km
6 lubrication points (e.g. ZP) 1.8cm
3
/ 100km 2.4cm
3
/ 100km
9 lubrication points (e.g. CP, ZP
H-loader)
2.7cm
3
/ 100km 3.6cm
3
/ 100km
10 lubrication points (e.g. FP) 3.0cm
3
/ 100km 4.0cm
3
/ 100km
Tab.6-2 Recommended lubrication quantity (P
t
)
6.4.3 Minimum lubrication quantity
Splitters only function correctly if > 0.5 cm
3
of lubricant is produced at their
input per lubrication cycle.
Operation OPERATING MANUAL FlexxPump4N Lubrication System
3422906891_v1.0_EN-US
80