Malfunction Cause Measure
Overpressure • Check lubrication lines
• Rectify causes (defective lubrication line, hardened lubricant, etc.)
• Switch lubrication system off and on, or acknowledge the error
Undervoltage or overvoltage • Switch off lubrication system
• Check supply voltage and compare with specified parameters
• Replace defective electronic components
• Switch on lubrication system
• Acknowledge error if necessary
internal error Disassemble entire lubrication system with screwed on lubricant cartridge and send back to Güdel along with a comprehensive
fault description
An internal error is usually in the electronics of the FlexxPump4. It cannot be rectified by you on site.
Tab.5-7 Malfunctions / Troubleshooting
Commissioning OPERATING MANUAL FlexxPump4N Lubrication System
3422906891_v1.0_EN-US
68
To Next Page
Loading...