GUDEL FlexxPump4 N - Maintenance Procedures; Maintenance Introduction and Safety

7 Maintenance
7.1 Introduction
Maintenance
tasks
The listed tasks have to be carried out at the prescribed time intervals. If they
are not carried out at the specified intervals or improperly, all warranty is
voided. Observing these obligations is a significant condition so that the prod-
uct performing without malfunction as well as its long service life.
Work sequences
Perform the work sequences in the order described. Perform the described
tasks at the specified times. This ensures a long service life for your product.
Original spare
parts
Only use original spare parts. Ü2145
Tightening torques
Unless otherwise indicated, adhere to the tightening torques of Güdel.
ÜChapter13,2154
7.1.1 Safety
Only perform the tasks described in this chapter after you have read and un-
derstood the chapter "Safety". Ü215
It concerns your personal safety!
DANGER
Hazardous voltage
The product contains components that are energized with hazardous volt-
ages. Touching these components will cause an electric shock. Electric shocks
can be fatal!
Before working in the danger area:
• Switch off the superordinate main power supply
• Secure the superordinate power supply against being switched on again
(main switch of complete system)
• Ground the equipment
Maintenance
OPERATING MANUAL FlexxPump4N Lubrication
System
3422906891_v1.0_EN-US
95