GW Instek PEL-3000 Series - Page 129

FUNCTION MENU
127
Sequence 1
STEP 01
STEP 02
:
STEP N
Sequence 2
STEP 01
STEP 02
:
STEP N
Sequence 10
STEP 01
STEP 02
:
STEP N
Start Sequence
:
:
:
:
Description
Normal Sequence configuration is split into
Timing Edit configuration and Data Edit
configuration.
Timing Edit configuration is used to configure the
actual sequences, such as mode, range, loops and
chains.
Data Edit configuration is used to create the actual
steps used in each sequence.
See below for a description of each.
Timing Edit
Overview
A Normal Sequence contains the following timing
settings for each sequence:
Setting
Setting Range
Description
Start
S01 - S10
Sets which sequence is used to
start a chain of Normal
Sequences.
Seq.No
S01 - S10
Sets the current sequence to
edit.