GW Instek PEL-3000 Series - CP Mode

PEL-3000(H) User Manual
58
Display
Mode
CV
I Range
H 8.75A
V Range
L 80V
Response
Slow
Configure
0.000
V
0.0000
A
0.00
W
CV B Value 80.000
CV A Value 80.000
LOADRS232
A Value
Fine
01/Oct/2018
V
V
Mode
Current range
Voltage
range
Active
setting
Current setting
Voltage
settings
Note
Basic CV mode configuration is complete. See page 65
for more configuration options.
The current range and voltage range applies to all the
operating modes.
CP Mode
Description
In Constant Power Mode, the unit will maintain a
constant power by varying the current. For more
details on CP mode, see the appendix on page 225.
Warning
If you change the mode or the range when the load is
already on, the load will be turned off automatically.
Operation
1. Make sure the load is off.
2. Press
Main
.
3. Select CP mode with the Mode[F1] soft-key.
4. Select the current range with the I Range[F2]
soft-key.
Range:
High, Middle, Low
5. Select the voltage range with the V Range[F3]
soft-key.
Range:
High, Low