GW Instek PEL-3000 Series - Uvp

PEL-3000(H) User Manual
84
Display
8.653
V
50.006
mA
0.4327
W
CV B Value 80.000
CV A Value 80.000
LOADRS232
A Value
Fine
01/Oct/2017
V
V
OPP Alarm
Please Press Enter
To Clear Alarm
OPP
OPP indicator
Alarm message
when OPP is
set to Load Off
Mode
CV
I Range
L87.5mA
V Range
L 80V
Response
Fast
Configure
UVP
Description
If the UVP is tripped, the PEL-3000(H) will turn off
the load.
The UVP levels can be set from 0V to 10% higher
than the rating voltage.
Operation
1. Press
Main
> Configure[F5] > Protection[F1]
and set the UVP Level.
Range:
UVP Level: OFF, 0-Rating voltage + 10%
Alarm
 The UVP indicator and a message will only
appear on the screen when the input voltage is
below the UVP level. The Enter key must be
pressed to clear the alarm message.
 To clear the UVP indicator, remove the cause of
the under voltage - i.e., increase the input
voltage.