GW Instek PEL-3000 Series - Using the Rear Panel Input Terminals

GETTING STARTED
35
Using the Rear Panel Input Terminals
Description
The rear panel input terminals accept up to M8-
sized crimped terminals. The rear terminals come
with a load input terminal cover for safety.
Caution
The front panel input terminals on the PEL-3000(H)
are physically connected to the rear panel terminals.
Steps
1. Turn the power off from the rear panel or put
the unit into standby mode.
2. Turn the power off from the DUT.
3. Connect the load wires to the input terminals:
 Connect the positive (+) input terminal on the
load generator to the high potential output of
the DUT.
 Connect the negative (-) input terminal to the
low potential output of the DUT.
+ potential
- potential