GW Instek PEL-3000 Series - Interface Configuration; Configure to USB Remote Interface; Configure GPIB Interface

PEL-3000(H) User Manual
196
Interface Configuration
Configure to USB Remote Interface
USB
configuration
PC side connector
Type A, host
PEL-3000(H) side
connector
Rear panel Type B, slave
Speed
2.0 (full speed)
USB Class
USB CDC ACM
Note
Before USB can be used for remote control, it is
necessary to install the PEL-3000(H) USB device
driver, located on the accompanying User Manual CD.
Operation
1. Connect the USB cable to the rear panel USB B
port.
2. Press
Shift
+
Utility
Help
> Interface[F3] and set
the Interface setting to USB.
Configure GPIB Interface
To use GPIB, the optional GPIB port must be installed. See page 212
for installation details.
Operation
1. Ensure the PEL-3000(H) is off before
proceeding.
2. Connect a GPIB cable from a GPIB controller to
the GPIB port on the PEL-3000(H).
3. Turn the PEL-3000(H) on.
4. Press
Shift
+
Utility
Help
> Interface[F3] and set
the Interface setting to GPIB.