GW Instek PEL-3000 Series - PEL-3000(H) Default Settings

APPENDIX
213
PEL-3000(H) Default Settings
The following default settings are the factory configuration settings
for the PEL-3000(H).
Main Settings
Item
Panel Settings
Setup Memory Settings
(all 100 sets)
Current(CC)
0 A
0 A
Conductance(CR)
0 S
0 S
Voltage(CV)
Maximum value
Maximum value
Wattage(CP)
0 W
0 W
+CV
OFF
OFF
Current range
H
H
Voltage range
150 V/800 V
150 V/800 V
Load on/off
Load off
Load off
Operation mode
CC
CC
Slew rate
Maximum value of H
range
Maximum value of H
range
Preset memories
Settings above in each
mode
Settings above in each
mode
Main > Configure > Protection
Item
Panel Settings
Setup Memory Settings
(all 100 sets)
OCP Level
Maximum value
Maximum value
OCP Setting
LIMIT
LIMIT
OPP Level
Maximum value
Maximum value
OPP Setting
LIMIT
LIMIT
UVP value
OFF
OFF
OVP value
OFF
OFF
Main > Configure > Other
Item
Panel Settings
Setup Memory Settings
(all 100 sets)
Soft Start
OFF
OFF
Von Voltage
0.00V
0.00V
Von Latch
ON
ON
Von Delay
2.0 ms
2.0 ms
Von Delay-CR
5.0 ms
5.0 ms
Short Key
Toggle
Toggle