FUNCTION MENU
133
Time
LOAD
RAMP
TRIG OUT
PAUSE
6. If you wish to edit a previously inserted
point/step, use the Step parameter.
Steps can only be selected after they have
already been inserted.
7. The currently selected step can be deleted
using the Delete Point[F2] function.
8. After all the steps for the sequence are
complete, press Save[F3] to save the steps.
Data Edit for Normal Sequence configuration is
complete.
Go to Timing Edit for Normal Sequences to
edit the sequence. Page 130.
Go to Running a Normal Sequence to run the
normal sequence. Page 133.
Running a Normal Sequence
Unlike a normal static or dynamic load, a load
created with the Normal Sequence function is
turned on by pressing the Shift and Load keys.
> Normal Sequence[F2].
2. Turn normal sequence mode on by setting
N. Seq.[F1] to On.
will appear at the top of the display when
N. Seq. is On.
To Next Page
Loading...
Need help?
General
