GW Instek PEL-3000 Series - Using the Front Panel Input Terminals

PEL-3000(H) User Manual
34
Using the Front Panel Input Terminals
Description
The front panel input terminals feature polarity-
distinct caps and accept M6 sized crimped
terminals.
Caution
The front panel input terminals on the PEL-3000(H)
are physically connected to the rear panel terminals.
Steps
1. Turn the power off from the rear panel or put
the unit into standby mode.
2. Turn the power off from the DUT.
3. Connect the load wires to the input terminals:
 Connect the positive (+) input terminal on the
load generator to the high potential output of
the DUT.
 Connect the negative (-) input terminal to the
low potential output of the DUT.
+ potential
- potential
Negative
terminal
Positive
terminal