GW Instek PEL-3000 Series - Load Default Settings; Setting the Date and Time

GETTING STARTED
29
the settings from when the unit was last powered
down.
Note
If the PEL-3000(H) fails to start up properly or does
not turn on, please see you local distributor.
Load Default Settings
Description
When first using the PEL-3000(H), recall the
factory default settings to ensure the unit is in a
known state. See page 213 for a list of the default
settings.
Operation
1. Press
Shift
+
File
FUNC
.
Select Media/Default[F1].
Select Factory Default[F2].
Media
Default
Factory
Default
Save Recall
LOADRS232
A Value
03/Oct/2018
Load Default Setup
CC
8.75A
800V
Static
Recall The Default Settings!
Pressing F2 Again will
Warning!!!
Setting the Date and Time
Description
The date and time settings are used to time-stamp
files when saving files.
 The date is shown on top of the display.