GW Instek PEL-3000 Series - Step Resolution Configuration; Cursor Mode Configuration

OPERATION
79
Step Resolution Configuration
There are two different ways to set the resolution when using the
scroll wheel to edit parameters. Step Mode and Cursor Mode. Step
Mode is the default method. Only one mode can be active at a time;
When one mode is active, the other mode is deactivated.
Cursor Mode Configuration
Description
Cursor mode allows you to edit the selected
parameter one digit at a time. When editing a
parameter, pressing the scroll wheel determines
which digit is selected. Turning the scroll wheel
will then edit the parameter by the step resolution
of the digit.
See the Conventions section on page 45 for
operation details.
Operation
1. Press
Main
> Configure[F5] > Next Menu[F4]
> Knob[F2] and set the Status setting is set to
Cursor.
Display
Parallel Knob External
Previous
Menu
3.00
CCL Step 0.300
CCM Step 0.00300
LOADRS232
01/Oct/2018
mS
mA
A
CRH Step
CCH Step
Status
0.0300
Cursor
A
CC
8.75A
80V
Static
Configure