GW Instek PEL-3000 Series - Page 68

PEL-3000(H) User Manual
66
Level
Time
Level 2
Level 1
Timer1 Timer2 Timer1
Dynamic Mode
Note
Dynamic mode is not available for CV mode.
Operation
1. Make sure the load is off.
2. Press
Main
.
3. Select Dynamic or Static mode with the
Function[F4] soft-key.
 A different switching function can be set for
CC, CR and CP mode.
4. For dynamic mode, set the Timer1 and Timer2
parameters using the scroll wheel and number
pad.
 Timer1 sets the Level1 on-time.
 Timer2 sets the Level2 on-time.
 Take the slew rate settings into consideration
when setting the timers.
 The frequency of the dynamic switching is
output via the TRIG OUT BNC.
5. In the static mode, select either value A or value
B as the “active” value for execution followed
by pressing the
Shift
+
Preset
.
 The “active” value will be shown in the
Operation Status Panel.
 The load can be “on” when switching between
A Value and B Value.