EasyManuals Logo

H3C S5130S-EI series User Manual

H3C S5130S-EI series
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
3
Safety recommendations
To avoid equipment damage or bodily injury, read the following safety recommendations before
installation. Note that the recommendations do not cover every possible hazardous condition.
Before cleaning the switch, remove all power cords from the switch. Do not clean the switch
with wet cloth or liquid.
Do not place the switch near water or in a damp environment. Prevent water or moisture from
entering the switch chassis.
Do not place the switch on an unstable case or desk.
Ensure good ventilation at the installation site and keep the air inlet and outlet vents of the
switch free of obstruction.
Connect the yellow-green protection grounding cable before power-on.
Make sure the power source voltage is as required.
To avoid electrical shocks, do not open the chassis while the switch is operating or when the
switch is just powered off.
To avoid ESD damage, wear an ESD wrist strap to hot-swap a power module.
Examining the installation site
The switch must be used indoors. You can mount your switch in a rack or on a workbench, but make
sure:
Adequate clearance is reserved at the air inlet and exhaust vents for ventilation.
The rack or workbench has a good ventilation system.
The rack is sturdy enough to support the switch and its accessories.
The rack or workbench is reliably grounded.
To ensure correct operation and long service life of your switch, install it in an environment that meets
the requirements described in the following subsections.
Temperature/humidity
Maintain temperature and humidity in the equipment room as described in "Technical specifications."
Lasting high relative humidity can cause poor insulation, electricity leakage, mechanical
property change of materials, and metal corrosion.
Lasting low relative humidity can cause washer contraction and ESD and cause problems
including loose mounting screws and circuit failure.
High temperature can accelerate the aging of insulation materials and significantly lower the
reliability and lifespan of the switch.
For the temperature and humidity requirements of different switch models, see "Appendix A Chassis
views and technical specifications."
Cleanliness
Dust buildup on the chassis might result in electrostatic adsorption, which causes poor contact of
metal components and contact points, especially when indoor relative humidity is low. In the worst
case, electrostatic adsorption can cause communication failure.

Table of Contents

Other manuals for H3C S5130S-EI series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the H3C S5130S-EI series and is the answer not in the manual?

H3C S5130S-EI series Specifications

General IconGeneral
SeriesS5130S-EI
CategorySwitch
MAC Address Table Size16K
VLAN4K VLANs
ManagementWeb, CLI, SNMP
Operating Temperature0°C to 45°C
Storage Temperature-40°C to 70°C
Operating Humidity5% to 95% (non-condensing)
Ports10/100/1000BASE-T ports
Layer SupportLayer 3
StackingSupported
Power SupplyAC/DC
PoESupported on some models
Dimensions (W x D x H)440 x 43.6 mm

Related product manuals