H3C S5130S-EI series - SFP+ Port

83
Table 30 FE SFP transceiver modules
FE SFP transceiver
module
Central
wavelength
Connector Fiber
Max
transmission
distance
SFP-FE-SX-MM1310-A 1310 nm LC
• 50/125 µm,
multimode
• 62.5/125 µm,
multimode
2 km (1.24 miles)
SFP-FE-LX-SM1310-A 1310 nm LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-LX-SM1310-D 1310 nm LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-LH40-SM1310 1310 nm LC
9/125 µm, single
mode
40 km (24.86 miles)
SFP-FE-LH80-SM1550 1550 nm LC
9/125 µm, single
mode
80 km (49.71 miles)
SFP-FE-
LX-SM1
310-BIDI
You must
use these
two
transceiver
modules in
pairs.
• TX: 1310 nm
• RX: 1550 nm
LC
9/125 µm, single
mode
15 km (9.32 miles)
SFP-FE-
LX-SM1
550-BIDI
• TX: 1550 nm
• RX: 1310 nm
LC
NOTE:
•
As a best practice, use H3C SFP transceiver modules and cables for the SFP ports.
•
The H3C SFP transceiver modules and cables available for the SFP ports
are subject to change
over time. For the most up-to-date list of H3C SFP transceiver modules and cables
available for
the SFP ports, contact your H3C sales representative or technical support engineer.
•
For the specifications of the H3C SFP transceiver modules and cables, see H3C Transceiver
Modules User Guide.
SFP+ port
To connect SFP+ ports over a long distance, use SFP/SFP+ transceiver modules and optical fibers.
To connect SFP+ ports over a short distance, use SFP+ cables. The SFP+ ports on the switch
support the following transceiver modules and cables:
•
GE SFP transceiver modules in Table 29.
•
10-GE SFP+ transceiver modules in Table 31.
•
10-GE SFP+ cables in Table 32.