Haas Mill User Manual

113
G Codes
96-8000 rev R June 2007
G89 Bore In, Dwell, Bore Out Canned Cycle (Group 09) ...............................................................145
G90 Absolute Position Commands (Group 03) ................................................................................146
G91 Incremental Position Commands (Group 03) ...........................................................................146
G92 Set Work Coordinate Systems Shift Value (Group 00) ............................................................146
G93 Inverse Time Feed Mode (Group 05) .......................................................................................147
G94 Feed Per Minute Mode (Group 05) ...........................................................................................147
G95 Feed per Revolution (Group 05) ...............................................................................................147
G98 Canned Cycle Initial Point Return (Group 10) .........................................................................147
G99 Canned Cycle R Plane Return (Group 10) ...............................................................................147
G100 Cancel Mirror Image (Group 00)..............................................................................................147
G101 Enable Mirror Image (Group 00)..............................................................................................147
G102 Programmable Output to RS-232 (Group 00) .........................................................................149
G103 Limit Block Buffering (Group 00) ............................................................................................150
G107 Cylindrical Mapping (Group 00)...............................................................................................150
G110-G129 Coordinate System #7-26 (Group 12) ............................................................................151
G136 Automatic Work Offset Center Measurement (Group 00).....................................................152
G141 3D+ Cutter Compensation (Group 07) ...................................................................................153
G143 5-Axis Tool Length Compensation + (Group 08) ...................................................................154
G150 General Purpose Pocket Milling (Group 00)..........................................................................155
G153 5-Axis High Speed Peck Drilling Canned Cycle (Group 09) .................................................160
G154 Select Work Coordinates P1-P99 (Group 12).........................................................................160
G155 5-Axis Reverse Tap Canned Cycle (Group 09) ......................................................................161
G161 5-Axis Drill Canned Cycle (Group 09) .....................................................................................162
G162 5-Axis Spot Drill Canned Cycle (Group 09) ............................................................................162
G163 5-Axis Normal Peck Drilling Canned Cycle (Group 09) .........................................................163
G164 5-Axis Tapping Canned Cycle (Group 09) ..............................................................................164
G165 5-Axis Boring Canned Cycle (Group 09).................................................................................164
G166 5-Axis Bore and Stop Canned Cycle (Group 09) ...................................................................165
G169 5-Axis Bore and Dwell Canned Cycle (Group 09) ..................................................................165
G174 CCW Non-Vertical Rigid Tap (Group 00).................................................................................166
G184 CW Non-Vertical Rigid Tap (Group 00) ...................................................................................166
G187 Setting the Smoothness Level (Group 00) ............................................................................166
G188 Get Program From PST (Group 00).........................................................................................166
G65, the Macro Subroutine Call, is described in the Macro chapter.

Haas Mill Specifications

General

Travels X Axis	Varies by model
Travels Y Axis	Varies by model
Travels Z Axis	Varies by model
Spindle Speed	Varies by model
Spindle Motor	Varies by model
Table Size	Varies by model
Rapid Traverse Rates	Varies by model
Tool Capacity	Varies by model
Max Cutting Rate	Varies by model
Spindle Taper	Varies by model