4
Safety
96-8000 rev R June 2007
USES AND GUIDELINES FOR PROPER MACHINE OPERATION
All milling machines contain hazards from rotating cutting tools, belts and pulleys, high voltage electricity,
noise, and compressed air. When using milling machines and their components, basic safety precautions
should always be followed to reduce the risk of personal injury and mechanical damage. READ ALL APPRO-
PRIATE WARNINGS, CAUTIONS, AND INSTRUCTIONS BEFORE OPERATING THIS MACHINE.
MODIFICATIONS TO THE M ACHINE
DO NOT modify or alter this equipment in any way. If modifications are necessary, all such requests must be
handled by Haas Automation, Inc. Any modification or alteration of any Haas machining center could lead to
personal injury and/or mechanical damage and will void your warranty.
SAFETY P LACARDS
To help ensure that CNC tool dangers are quickly communicated and understood, hazard symbol decals are placed on
Haas Machines in locations where hazards exist. If decals become damaged or worn, or if additional decals are needed
to emphasize a particular safety point, contact your dealer or the Haas factory. Never allow anyone to alter or
remove any safety decal or symbol.
Each hazard is defined and explained on the general safety decal, located at the front of the machine. Particular loca-
tions of hazards are marked with warning symbols. Review and understand the four parts of each safety warning, ex-
plained below, and familiarize yourself with the symbols on the following pages.
To Next Page
Loading...
Need help?
General
