124
G Codes
96-8000 rev R June 2007
O1234 (G35)
M52
T1 M06
G00 G90 G54 X0 Y1.
G43 H01 Z0
G01 Z-1. F10.
M04 S200
G31 Y0.49 F5. M75
G01 Y1. F20.
Z0
Y-1.
Z-1.
G35 Y-0.49 D1 F5.
G01 Y-1. F20.
M62
G00 G53 Z0 M05
M30
G36 Automatic Work Offset Measurement (Group 00)
(This G-code is optional and requires a probe)
F Feedrate in inches (mm) per minute
I Optional offset distance along X-axis
J Optional offset distance along Y-axis
K Optional offset distance along Z-axis
X Optional X-axis motion command
Y Optional Y-axis motion command
Z Optional Z-axis motion command
Automatic Work Offset Measurement (G36) is used to command a probe to set work fixture offsets. A G36 will feed
the axes of the machine in an effort to probe the workpiece with a spindle mounted probe. The axis (axes) will
move until a signal from the probe is received, or the travel limit is reached.
Tool offsets (G41, G42, G43, or G44) must not be active this function is preformed. The currently active work
coordinate system is set for each axis programmed. The point where the skip signal is received becomes the zero
position.
If an I, J, or K is specified, the appropriate axis work offset is shifted by the amount in the I, J, or K command. This
allows the work offset to be shifted away from where the probe actually contacts the part.
Notes:
The points probed are offset by the values in Settings 59 through 62.
Use G91 incremental moves when using a G36.
Use the assigned M-codes (for example M53 and M63) with a dwell to turn the spindle probe on or off.
Example:
M53
G04 P100
M63
To Next Page
Loading...
Need help?
General
