6
Safety
96-8000 rev R June 2007
DECLARATION OF W ARNINGS, CAUTIONS, AND N OTES
Throughout this manual, important and critical information is prefaced with the word “Warning”, “Caution” and “Note”
Warnings are used when there is an extreme danger to the operator and/or to the machine. Take all steps neces-
sary to heed the warning given. Do not continue if you cannot follow the warning instructions. An example warning is:
WARNING!
NEVER PUT HANDS BETWEEN TOOL CHANGER AND SPINDLE HEAD.
Cautions are used when there is the potential for minor personal injury or mechanical damage, for example:
CAUTION! Power down the machine before performing any maintenance tasks.
Notes give additional information to the operator about a particular step or procedure. This information should be
taken into consideration by the operator as the step is performed to ensure there is no confusion, for example:
NOTE: If machine is equipped with the optional extended Z-clearance table, follow
these guidelines:
• Avoid extreme loads on the center of table or far end of table. The weight
of the part should be distributed evenly over the table or one pad.
• Flatness of part should be within 0.002".
MILL W ARNING D ECALS
To Next Page
Loading...
