187
Settings
96-8000 rev R June 2007
118 M99 Bumps M30 CNTRS
When this setting is ON, an M99 will add one to the M30 counters (these are visible on the CURNT COMNDS
displays). Note that an M99 will only increase the counters as it occurs in a main program, not a sub-program.
119 Offset Lock
Turning the setting ON will not allow the values in the Offset display to be altered. However, programs that alter
offsets will still be able to do so.
120 Macro VAR Lock
Turning this setting ON will not allow the macro variables to be altered. However, programs that alter macro variables
will still be able to do so.
121 APC Pal. One Load X
122 APC Pal. One Load Y
123 APC Pal. One Unload X
124 APC Pal. One Unload Y
125 APC Pal. Two Load X
126 APC Pal. Two Load Y
127 APC Pal. Two Unload X
128 APC Pal. Two Unload Y
129 APC Pal. 1 and 2 Safe X Pos
Settings 121-129 are the pallet positions for the X and Y axis. They are set at the time the APC is installed and
should not need altering.
130 Tap Retract Speed
This setting affects the retract speed during a tapping cycle. Entering a value, such as 2, will command the mill to
retract the tap twice as fast as it went in. If the value is 3, it will retract three times as fast. A value of 0 or 1 will have
no affect on the retract speed. (Range 0-4)
Entering a value of 2, is the equivalent of using a J code of 2 for G84 (Tapping canned cycle). However, specifying a J
code for a rigid tap will override setting 130.
Note: If the machine does not have the Rigid Tap option, this setting has no effect.
131 Auto Door
This setting supports the Auto Door option. It should be set to ON for machines with an autodoor. Also see M80/81
(Autodoor Open/Close M-codes).
The door will close when Cycle Start is pressed and will open when the program reaches an M00, M01 (with Optional
Stop turned on) or M30 and the spindle has stopped turning.
133 Repeat Rigid Tap
This setting ensures that the spindle is oriented during tapping so that the threads will line up when a second
tapping pass, in the same hole, is programmed.
134 Connection Type
This setting can be FLOPPY, NET, or ZIP. When it is set to FLOPPY, loading and saving programs is performed
using the floppy disk drive.
When it is set to NET, loading and saving occur through the user-supplied network connection.
When it is set to ZIP, program loading and saving occurs through the user-supplied Zip™ drive.
135 Network Type
This setting can be NONE, NOVELL, NT/IPX, NT/TCP or ADV/TCP. It specifies the user-supplied network connection
type. When it is set to NONE, only a floppy disk or a user-supplied Zip™ drive is accessible. If ADV/TCP is se-
lected, a setting page will appear in place of setting 135. To revert back, change “Net Type” to “None”.
To Next Page
Loading...
Need help?
General
