Haas Mill User Manual

191
Settings
96-8000 rev R June 2007
167-186 Periodic Maintenance
There are 14 items that can be monitored, as well as six spare items, in the periodic maintenance settings. These
settings will allow the user to change the default number of hours for each item when it is initialized during use. If the
number of hours is set to zero, the item will not appear in the list of items shown in the maintenance page of current
commands.
167 Coolant Replacement default in power-on hours
168 Control Air Filter Replacement default in power-on hours
169 Oil Filter Replacement default in power-on hours
170 Gearbox Oil Replacement default in power-on hours
171 Coolant Tank Level Check default in power-on hours
172 Way Lube Level Check default in motion-time hours
173 Gearbox Oil Level Check default in power-on hours
174 Seals/Wipers Inspection default in motion-time hours
175 Air Supply Filter Check default in power-on hours
176 Hydraulic Oil Level Check default in power-on hours
177 Hydraulic Filter Replacement default in motion-time hours
178 Grease Fittings default in motion-time hours
179 Grease Chuck default in motion-time hours
180 Grease Tool Changer Cams default in tool-changes
181 Spare Maintenance Setting #1 default in power-on hours
182 Spare Maintenance Setting #2 default in power-on hours
183 Spare Maintenance Setting #3 default in motion-time hours
184 Spare Maintenance Setting #4 default in motion-time hours
185 Spare Maintenance Setting #5 default in tool-changes
186 Spare Maintenance Setting #6 default in tool-changes
187 Machine Data Echo
This setting can be set ON or OFF. When set to ON, the data collection Q commands issued from the user’s PC
will be displayed on the PC screen. When set to OFF, these commands will not be displayed.
191 Default Smoothness
This setting may be set to ROUGH, MEDIUM, or FINISH and uses parameters 302, 303, 314, 749, and 750-754 and
G187 to set the smoothness and a maximum corner rounding factor. The default values are used when not overrid-
den by a G187 command.

Haas Mill Specifications

General

Travels X Axis	Varies by model
Travels Y Axis	Varies by model
Travels Z Axis	Varies by model
Spindle Speed	Varies by model
Spindle Motor	Varies by model
Table Size	Varies by model
Rapid Traverse Rates	Varies by model
Tool Capacity	Varies by model
Max Cutting Rate	Varies by model
Spindle Taper	Varies by model