Operation
64
96-8000 rev R June 2007
Sending Multiple Programs Using Program Numbers. The Send Floppy under the I/O menu of the Advanced
Editor allows programs to be saved to floppy disk. It will prompt, “Enter Floppy File Name”; enter a file name and
press Write/Enter. If a file name is not entered, the control will save each program using the five-digit program
number as the file name.
Sending a Program File from LIST PROG Display. Files can be sent to a floppy disk or through the RS-232
port from the LIST PROG display. Use the cursor arrows and the Insert key to select the program(s), or “ALL” to
send all of them under one file name. When F2 is pressed (to send the selected programs), the control will ask for
a file name (8CHRCTRS.3XT). Press F2 a second time to send it. You can also use the I/O menu in the Advanced
Editor to send and receive program files.
Sending Multiple Programs from LIST PROG Using SEND RS232. Several programs can be sent to the serial
port by typing all the program names together on the input line without spaces (e.g., O12345O98765) and pressing
SEND RS232.
Send and Receive Offsets, Settings, Parameters and Macro Variables to/from Disk. Offsets, settings,
parameters and macro variables can be saved to a floppy disk. Press List Prog, and select a display page (e.g.
OFSET, SETNG). Type in a file name and press F2 (or F3 to read that file from a disk).
Send and Receive Offsets, Settings, Parameters and Macro Variables to/from RS232. Offsets, settings,
parameters and macro variables can be saved to the RS-232 port. Press List Prog, and select a display page (e.g.
OFSET, SETNG). Enter a file name and press Send RS232 to send that display page to the RS-232 port. Press
RECV RS232 to read the file via RS-232.
Deleting a Program File from a Floppy Disk. A file can be erased from the floppy drive from the LIST PROG
display. Type “DEL <file name>” and press Write Enter.
To Next Page
Loading...
Need help?
General
