Section 2
Page 33
UVTOCUnpacking Installation Setup.fm Wiring the Instrument
Figure 11 Termination Printed Circuit Board Assembly (P. N. 130143)
1. Optional Serial Communications Network Card (section 2.5 on page 41)
2. Pressure Sensor with Pneumatic Connection to UV Block Carrier Gas
3. NDIR Cell Heater LED. (Flashes on and off to indicate heat cycle).
4. 24V Power Input Connection
5. JP1. Pins 2 and 3 are jumpered when optional RS422/485 network card is installed (section 2.5 on page 41)
6. Sparger Flow Bubble Detector LED. Flashes on bubble detection at sparger inlet (section 8.6.7 on page 144).
7. Sparger Bubble Detector Connection
8. UV Flow Bubble Detector Connection
9. UV Block Flow Bubble Detector LED. Flashes on bubble detection at UV block (section 8.6.7 on page 144).
10. Remote Control Input (section 5.2.6.5 on page 80).
11. Dual Stream Valve Connection
To Next Page
Loading...
