9705 - Initialization 13 of 82
KSS - March 2006 - Edition 1
HIAC Operator Manual
2 Initialization
This section contains information on unpacking and setting up the Model 9705 Liquid Particle
Counting System so it is ready for use.
CAUTION:
Do not attempt to operate or set up the 9705 without reading and following the procedures
described in this section.
2.1 Inspection and Unpacking
The 9705, shown in Figure 2-1, is shipped in a single carton. Visually inspect the outside of the
carton for signs of damage (dents, tears, etc.) that may have occurred during shipping and
bring the damage to the attention of the shipper. Save this carton for reshipping the 9705.
Inspect the interior of the carton for damage to the contents. Compare the contents of the
carton to the shipping papers to assure all items are present. If any items are missing, contact
the factory at 800.866.7889 or +1-541.472.6500 or a local Hach Ultra representative.
WARNING
Never reach inside the bottle dock. There is a sharp needle inside the bottle dock; personal
injury may occur.
Fig 2-1 : 9705 Particle Counting System
touch screen
printer
bottle dock
syringe access
To Next Page
Loading...
