Page 104
"Error creating braille character set file"
Cause: There is not enough memory in the file system to generate the Braille
character sets.
"New braille set file created! Please reload needed sets!"
Cause: The Braille character set file was recreated, because it was either missing
or its size was incorrect. You will have to reload the required character sets
into the Braille System.
"Braille set x is empty"
Cause: You are attempting to activate a Braille character set numbered x, but that
character set slot is empty.
"Error writing configuration file"
Cause: An error occurred while saving the configuration.
"Saving configuration, please wait!"
Cause: This message is displayed while the configuration file is being written.
"New configuration file created. Please check your settings!"
Cause: The configuration file was recreated, because it was either missing or its
data were incorrect. The settings have now reverted to factory defaults.
You should therefore check the settings and customize them to your liking.
"Fatal: Invalid MSGID! Please upload appropriate msg file!"
Cause: A message was requested that is not present in the currently loaded
message file. Loading the message file matching the current firmware will
resolve the problem.
"File in use by editor. Please close it first"
Cause: You are attempting to delete or transfer a file which is currently open in the
Editor.
Result: The file cannot be deleted.
Remedy: Return to the Editor, then close the file, and try again.
"Warning: Deleting this file can cause system instability"
Cause: You are attempting to delete a system file.
Result: The possible results depend on which file you are attempting to delete. For
example, if you delete the file containing the Braille character sets, that file
will be regenerated once the Braille System has been turned off and back
on again, and you must then download the needed character sets again.
However, if you delete the message file, the Braille System can no longer
operate until you have reloaded the message file.
It is therefore recommended that you delete system files only when you are
completely clear on what the results will be.
You take on a great deal of responsibility by being given the option of
deleting system files. Handy Tech Elektronik GmbH therefore accepts no
warranty claims arising from any damage caused by deleting system files.
"System files cannot be deleted while the editor is active"
Cause: You are attempting to delete a system file while the Editor is in its suspen-
ded state. However, this is not possible, because the Editor accesses
system files.
Result: See above.
Remedy: First, close the Editor, then delete the system file. Please note that deleting
any system file can have serious consequences. Your Braille System may
be inoperable until the system file has been reloaded again.
To Next Page
Loading...
Need help?
General