Page 94
Please note: In Version 2.00 of the Braille System firmware, there are no descriptive texts
regarding file system errors. If you are contacting us in regard to file system errors,
providing the error number will be sufficient.
Note:
If you receive a fatal error of the file system message after loading new firmware, the
reason may be that the file system's version number has changed.
10.1.2 Saving Files in Case of Fatal Errors
If you receive a fatal error message, but you have not made any changes to the firmware,
it will unfortunately not be possible to salvage your files. Although this is a very unlikely
scenario, we recommend regularly saving your files on a separate system, e.g. a PC.
In addition, it is not impossible that a fatal error of the file system message is received after
you have updated the firmware, but relevant data are still stored on the Braille System.
!!! IMPORTANT !!!
If this is the case, do NOT confirm the error message by pressing [ESC]! Once the
automatic reformatting has begun, you cannot salvage any of your data!
Instead, turn off the Braille System and restart it in EPROM mode by holding down [8]
during start up. Load the previous firmware version into the Braille System. Following this,
save all of your files on a PC.
10.2 Symbols
The symbols located on the underside of the unit have the following meanings:
Please read the information in the manual!
Applied Part, Type B
10.3 Safety Information under the Standards for Medical Devices
Medical electric devices are subject to special precautions in regard to electromagnetic
compatibility and must be installed and taken into operation according to the directions
contained in this manual. Please review also the general safety information in Section 10.4
below.
Portable mobile HF communications facilities may affect electrical devices.
To Next Page
Loading...
Need help?
General