Description and principle of operation
Iss. a – Translation of the original version
Doc. Ref. : SOUND2.940.001
2. Then increase or decrease the value of the selected digit using the “Up” key or the “Down” key .
3. Select and change another number or confirm by pressing the Enter key .
To select text:
A list of choices is displayed on the screen. The selection is highlighted with an arrow ↑or ↓ showing the
movements that are authorised.
Using the “Up” key or “Down” key to the right of the screen, select the desired value and confirm
by pressing the “Enter” key .
2.2.1.3. Keys for direct access or commands
The “Automatic calibration” key displays the Calibration menu.
The user can choose the number of Calibration points and the Calibration level. This
function is only available in the Maintenance profile.
When this key is pressed, the screen displays the alarm page.
“Alarm” key: When the red LED on this key flashes, it indicates that there is a new
alarm.
The “2/3” means: Alarm n°2 displayed in a list of 3 alarms.
Press the left “Reset” key to turn off the LED if the cause of the alarm has
disappeared. If the cause of the alarm is still present, the LED will stop flashing and
stay permanently lit until the problem is resolved, after which it will switch off
automatically.
This key will open a short message associated with the new alarm.
Press the key on the right to display a page showing the history of the last 256
alarms.
Use the “Up” and “Down” keys to scroll through the alarm history.
This softkey will clear the history list.
To Next Page
Loading...
