Hasler Sound 2 - Parameters, Measures, Calibration, and Cross Talk Menus

Maintenance
Page 55 / 64
Iss. a – Original Instruction Manual
2024/01/05
Doc. Ref. : SOUND2.940.001
8.6.4. “Parameters” menu
See section
5.5 page 31.
8.6.5. “Measures” menu
See section
6.5.4 page 41.
8.6.6. “Calibration” menu
See section
5.6 page 32.
8.6.7. “Cross Talk” menu
If other mills exert an influence of undesirable frequencies, the problem can be solved by cross-compensation
known as crosstalk.
Figure 45: Example with two mills in the same room
Accessing the menu
To go to the “Cross Talk” menu:
1. Press the “Menu” key .
2. Select the “Cross Talk” menu and press Enter.

Figure 46: “Cross Talk” menu
Submenu
Description
CT Enable (crosstalk
enabled)
This parameter is used to enable crosstalk.
When this value is disabled, no parameters are displayed in this menu.
1
Mill
2
Mill
Undesirable Influence
MIC_IN (J1)
CT_IN (J7)
MIC_IN (J1)
CT_OUT (J11)
CT_OUT (J11) CT_IN (J7)