Hasler Sound 2 - Machine Operation and Powering; Operator Menu Structure and Navigation

Page 38 / 64
Use – Operation
Iss. a – Translation of the original version
2024/01/05
Doc. Ref. : SOUND2.940.001
6.4. OPERATION
6.4.1. Powering up/commissioning the machine
If the SD card is inserted, the SOUND2 will boot up from the card when it is switched on in order to
install the parameters contained on the card. In this case, it may take a few minutes to start.
When the SOUND 2 is powered up, it automatically begins commissioning or starting up.
Connect the SOUND2 power supply to the electrical cabinet or the power socket.
6.4.2. Powering down/decommissioning the machine
To switch off the SOUND 2, disconnect the power supply at the power socket or in the electrical cabinet.
6.5. USING THE HUMAN MACHINE INTERFACE
The software in Operator profile provides access to 4 menus:
−
“Alarm” menu,
−
“Measures” menu,
−
“Calibration” menu,
−
“System” menu.
6.5.1. Structure of the Operator menu
Figure 29: Operator menu structure
6.5.2. “System” menu
This menu, in the Operator profile, features the following submenus:
− General
− Security
− Software versions
6.5.2.1. “General” submenu
To go to this submenu: