Hasler Sound 2 - Figure 36: Calibration Datas Submenu; Figure 37: Actual Measures Submenu

Page 42 / 64
Use – Operation
Iss. a – Translation of the original version
2024/01/05
Doc. Ref. : SOUND2.940.001
Calibration Data
1. Press Enter in the “Calibration measurements” submenu to go to this submenu.

Figure 36: “Calibration Datas” submenu
Parameter
Description
Calib. N° Point
This is the number of the calibration point
Calib. State
If the SOUND2 is calibrated with a minimum of one point, calib. state = 1. If
the SOUND2 is waiting for a calibration, calib. state = 0.
Calibrated Level
Corresponds to the level of the calibration points.
Power Max
Corresponds to the maximum power measured during calibration.
Frequency
Corresponds to the first bandwidth frequency measured at the first
calibration point.
Actual Measurements
1. Press Enter in the “Actual Measures” submenu to go to this submenu.

Figure 37: “Actual Measures” submenu
Parameter
Description
Max Frequency
Corresponds to the maximum frequency of the actual measurement.
Power Avg
Corresponds to the average power of the actual measurement.
Power Max
Corresponds to the maximum power of the actual measurement.
Sample Frequency
Corresponds to the first bandwidth frequency measured at the first
calibration point.