Iss. a – Translation of the original version
Doc. Ref. : SOUND2.940.001
3. Enter the “Configuration” menu . The “Parameters” menu is displayed as follows:
Figure 24: “Parameters” menu
4. Use the Up and Down navigation keys to select the parameter to be changed, then press the Enter key.
5. The display shows the current value of the selected parameter, which can be modified. To modify it, use
the contextual selection keys to select the unit digit, tens digit or other digit to be modified, then press
the Up or Down keys to display the required number.
6. Repeat this operation until the desired value is obtained, then press the Enter key to save the new value.
The values to be entered are as follows:
5.6. VERIFICATION PRIOR TO INITIAL COMMISSIONING
To check that your SOUND2 is correctly configured, you can check the number of calibrated points. To do
this, press the “Calibration” key, then select “Calibration state”.
Figure 25: Checking calibration
You can change the Number of calibration points (“Calib. N° Point”) and check the “Calibrated level”.
If it is set to 0%, the point is not calibrated.
To Next Page
Loading...
