Hasler Sound 2 - Figure 49: System\General Menu

Page 58 / 64
Maintenance
Iss. a – Original Instruction Manual
2024/01/05
Doc. Ref. : SOUND2.940.001
8.6.9.1. “General” submenu
To go to the submenu,
1. Select the “General” menu and press Enter. The following screen is displayed:
Figure 49: “System\General” menu
Parameter
Description
Main Page Config.
This screen is used to change the parameter on the main screen.
A list of the different parameters is displayed in this menu.
Ctrl Operation Time
Time during which power was supplied to the SOUND 2.
Language
Selects the display language.
Date
Sets the date
Time
Sets the time
Clear memory
When this function is used, all specific parameters are cleared and replaced
by the default value.
Temperature
Indicates the temperature in the SOUND 2 unit.
Changing the language
1. In the “General” submenu, select “Language” and press Enter.
2. On the screen that is displayed, use the “Up” and “Down” buttons to select the desired language.
3. Press the “Enter” key to confirm your choice. The “General” submenu screen is displayed.
If a language has been selected by mistake, it may be very difficult to go back to this menu if the
characters displayed are not understood.
To avoid tedious searching, a shortcut has been created to return directly to the list of language
options. To do this:
− Open the Home page by pressing the key .
− Then simultaneously press the keys below the screen.
− The list of languages is displayed. Use the “Up” and “Down” keys to select the language you
require and press the Enter key.
Changing the display mode
The parameters on the main screen to be displayed can be modified.
− Noise level.
− Filling level. (Filling level = 1/Noise level)
To change the parameters to be displayed on the main screen:
1. Select “General” then press “Enter”.
2. Select “Main Page Config.” then press Enter.
A screen is displayed with 4 possible functions:
− Parameter 1
− Parameter 2
− Parameter 3