Hasler Sound 2 - Measures Menu: Calibration and Actual Data

Use – Operation
Page 41 / 64
Iss. a – Translation of the original version
2024/01/05
Doc. Ref. : SOUND2.940.001
Parameter
Description
CPU Board SW
Indicates the software version of the program installed on the CPU board
SW DSP
Indicates the software version of the digital audio process installed on the
CPU board
CPU Board HW Type
Encrypted code with hardware version of the CPU board.
For a SOUND2 Advanced, the “CPU Board SW” software version will be “2.0.1.0”.
6.5.3. “Alarm” menu
To go to the alarms:
1. Press the “Menu” key .
2. Select the Alarm menu and press Enter.
3. Press Enter in the “History” submenu and the alarm history is displayed.

Figure 34: “Alarm history” menu
6.5.4. “Measures” menu
The measurement menu can display each calibration parameter and the current measurement parameters.
There are two types of measurement in this menu:
• Measurements used for calibration in the “Calibration datas” menu.
• Actual measurements in the “Actual Measures” menu
To go to the “Measures” menu:
1. Press the “Menu” key .
2. Select the “Measures” menu and press Enter. The following screen is displayed:
Figure 35: “Measures” menu