HBM MP85A - Page 114

FAQs: Frequently asked questions (MP85A and PME Assistant)
114 A0293_06_E00_03 HBM: public MP85A
7. If you have changed a digit, press the SET key.
8. After the IP address has been displayed, you will see the subnet mask.
Change it as required.
9. Press and hold the SET key for at least two seconds to save your changes.
Save? will now flash on the display.
10.Press the SET key to confirm.
A flashing double arrow and Yes appear on the second line.
11.Press the SET key to confirm.
CAN bus interface
Most parameters can be changed only manually; the PME Assistant must not
be connected to the MP85A via this interface during configuration. Exit the pro
gram if necessary.
Tip
You do not have to exit or close the online help when you exit the PME Assis
tant.
Setting the baud rate on the MP85A:
1. Press and hold the SET key for at least two seconds.
The CAN BUS display appears.
2. Press the SET key again.
Baud rate appears along with the currently set value.
3. Press the SET key once more.
A flashing double arrow appears to the left in front of the currently set baud
rate.
4. Press the + or  keys to change this value.
5. When the desired figure is shown, press the SET key.
6. Now press and hold the SET key for at least two seconds.
Save? will now flash on the display.