Starting up/Setup mode
50 A0293_06_E00_03 HBM: public MP85A
7 Starting up/Setup mode
To prepare the MP85A process controller for a measurement task, ensure the
following requirements are met and/or perform the relevant steps:
S You require an MP85A process controller and either the PME Assistant or
INDUSTRYmonitor program.
S Set up the hardware: transducer, MP85A process controller, PC with
software (see section 7.2).
S Install the software (see section 7.3).
To connect the MP85A process controller to a PC, you will need the following:
S An Ethernet (crossover) cable (see section 7.2.2) for Ethernet operation,
S A CAN adapter (see section 7.2.3), either PCAN USB‐to-CAN or PCAN
card, for operation via the CAN interface.
Connect the MP85A process controller to a PC via the Ethernet cable or the
CAN adapter. Once you have launched the software, you can set up the
MP85A process controller with the PME Assistant (see section 7.4).
To Next Page
Loading...
