FAQs: Frequently asked questions (MP85A and PME Assistant)
MP85A A0293_06_E00_03 HBM: public 147
S The transfer or MMC/SD card memory is nearly full.
S The output was set via the interface.
13.24 How can I generate a log printout of a process?
► Load the process(es) you wish to log via MEASURE + VIEW Display
saved data. The file selection dialog enables you to enter various search
criteria and search several subfolders.
► Open the print preview via .
► In the dialog box, click to print the desired number of pages you require.
You can choose portrait or landscape format just before printing, or preset the
required orientation in Windows.
You can integrate your company logo in the display and the printout: To do
this, copy the file containing your logo, LOGO.BMP or LOGO.GIF (bitmap or
GIF format), to the PME Assistant installation directory. The logo will then
appear below the overall result.
13.25 How can I transfer all the settings of one MP85A to
another device (cloning)?
You can save all the settings of an MP85A on the MMC/SD card using the key
board of the MP85A, and then transfer them to another MP85A.
Procedure for saving settings
► Press and hold the SET key for at least two seconds. The CAN BUS dis
play appears.
► Press the + key several times until System-State is displayed.
► Press the SET key. S-Status Save (Save system state) appears.
► Press the SET key to confirm. The data is now saved on the MMC/SD card.
Wait until the process is complete and the measured value is displayed
once more.
To Next Page
Loading...
